Dumps4cert.com : Latest Dumps with PDF and VCE Files
2018 May CompTIA Official New Released N10-006
100% Free Download! 100% Pass Guaranteed!

CompTIA Network Certification

Question No: 231 – (Topic 6)

A network technician was tasked to install a network printer and share it to a group of five human resource employees. The technician plugged the device into a LAN jack, but was unable to obtain an IP address automatically. Which of the following is the cause of the problem?

  1. DNS

  2. Wrong TCP port

  3. Split horizon

  4. DHCP scope

Answer: D

Question No: 232 – (Topic 6)

Which of the following protocols is used to encapsulate other network layer protocols such as multicast and IPX over WAN connections?

  1. MPLS

  2. ESP

  3. GRE

  4. PPP

Answer: C

Question No: 233 – (Topic 6)

Coverage analysis for a new implementation of 802.11n WLAN involves which of the following? (Select TWO)

  1. Humidity

  2. Temperature

  3. Heatmap

  4. Building material

  5. Sight lines

Answer: D,E

Question No: 234 CORRECT TEXT – (Topic 6)

SIMULATION

You have been tasked with setting up a wireless network in an office. The network will consist of 3 access points and a single switch. The network must meet the following parameters.

The SSIDs need to be configured as corpnet with a key of S3cr3t! The wireless signals should not interfere with each other

The subnet the Access points and Switch are on should only support 30 devices maximum The access Points should be configured to only support TKIP clients at a maximum speed

Instructions: Click on the devices to review their information and adjust the setting of the APs to meet the given requirements.

Dumps4Cert 2018 PDF and VCE

Answer: Here is the solution below.

Explanation:

This simulation is still under construction. On the first exhibit, the layout should be as follows

Access Point Name AP1

IP Address 192.168.1.3

Gateway 192.168.1.2 SSID corpnet

SSID Broadcast yes

Mode G Channel 1

Speed Auto Duplex Auto

WPA

Passphrase S3cr3t! Exhibit 2 as follows

Access Point Name AP2 IP Address 192.168.1.4

Gateway 192.168.1.2 SSID corpnet

SSID Broadcast yes

Mode G Channel 6

Speed Auto Duplex Auto

WPA

Passphrase S3cr3t! Exhibit 3 as follows

Access Point Name AP3 IP Address 192.168.1.5

Gateway 192.168.1.2 SSID corpnet

SSID Broadcast yes Mode G

Channel 11

Speed Auto Duplex Auto

WPA

Passphrase S3cr3t!

Question No: 235 – (Topic 6)

Which of the following attacks utilizes a wireless access point which has been made to look as though it belongs to the network in order to eavesdrop on wireless traffic?

  1. Evil twin

  2. Rogue access point

  3. WEP attack

  4. War driving

Answer: A

Question No: 236 – (Topic 6)

Which of the following encryption types would MOST likely be used for securing a client-to- server VPN connection?

  1. TKIP

  2. Kerberos

  3. ISAKMP

  4. AES

Answer: D

Question No: 237 – (Topic 6)

A network technician has downloaded the latest vendor switch O/S. which includes new features and enhancements. Which of the following should the technician perform FIRST when updating the switches?

  1. Backup the current configuration for each switch

  2. Install during non-business hours to test the system

  3. Test the O/S on one of the production switches

  4. Power cycle the company#39;s border router

Answer: A Explanation:

QUESTIONNO: 297

Which of the following protocols is used to send mail to another server on the Internet?

  1. RTP

  2. SNMP

  3. POP

  4. SMTP Answer: D

Question No: 238 DRAG DROP – (Topic 6)

DRAG DROP

Wireless network users recently began experiencing speed and performance issues after access point 2 (AP2) was replaced due to faulty hardware. The original network was installed according to a consultant#39;s specifications and has always worked without a problem.

You a network technician, have been tasked with evaluating the situation and resolving the issues to improve both performance and connectivity. Refer to the following exhibits and perform any necessary changes to the wireless and wired infrastructure by adjusting devices. Note: Adjust the LEAST number of devices needed to fix the issue.

Dumps4Cert 2018 PDF and VCE

Answer:

Dumps4Cert 2018 PDF and VCE

Explanation:

Dumps4Cert 2018 PDF and VCE

After you fix AP2, you must click on the switch, which will bring up the switch interface. Type in the two commands that they show there, to prove the fix. Donot worry that interface 4 is down, there is no interface 4 for you to do

Question No: 239 – (Topic 6)

An organization wants to improve its ability to detect infiltration of servers in a DMZ, IPS/IDS solutions are currently located on the edge between DMZ and Untrust, and DMZ and Trust. Which of the following can increase visibility inside the DMZ?

  1. Layer 7 firewall

  2. HoneypotC, NAC serverD, Host-based firewalls in the DMZ

Answer: A Explanation:

https://en.wikipedia.org/wiki/DMZ_(computing)

Question No: 240 – (Topic 6)

A technician receives a report that a user’s workstation is experiencing no network connectivity. The technician investigates and notices the patch cable running from the back of the user’s VoIP phone is routed directly under the rolling chair and has been smashes flat over time. Which of the following is the most likely cause of this issue?

  1. Cross-talk

  2. Electromagnetic interference

  3. Excessive collisions

  4. Split pairs

Answer: C

100% Dumps4cert Free Download!
Download Free Demo:N10-006 Demo PDF
100% Dumps4cert Pass Guaranteed!
Download 2018 Dumps4cert N10-006 Full Exam PDF and VCE

Dumps4cert ExamCollection Testking
Lowest Price Guarantee Yes No No
Up-to-Dated Yes No No
Real Questions Yes No No
Explanation Yes No No
PDF VCE Yes No No
Free VCE Simulator Yes No No
Instant Download Yes No No