Ensurepass.com : Ensure you pass the IT Exams
2018 Aug Cisco Official New Released 500-202
100% Free Download! 100% Pass Guaranteed!
CCIE Data Center (v2.0)
Question No: 121 – (Topic 2)
Which two Cisco Nexus 2000 Series Fabric Extenders support FCoE? (Choose two.)
-
2248TP
-
2232ET-P
-
2224TP
-
2232PP
-
2232TM-E
Answer: D,E Explanation:
Ref:http://www.cisco.com/c/en/us/products/collateral/switches/nexus-2000-series-fabric- extenders/data_sheet_c78-507093.html
Question No: 122 – (Topic 2)
Refer to the exhibit.
Which statement about these commands is true?
-
The outputs of the debug are redirected on file test on the quot;log.quot; directory.
-
The outputs of the debug are redirected to the logging buffer.
-
The command does not have an effect unless you configure quot;debug enablequot;.
-
If you are on a console connection, the outputs are shown after the event occurs.
Answer: A Explanation: Ref:
http://www.cisco.com/web/techdoc/dc/reference/cli/nxos/commands/fund/debug_logfile.htm l
Question No: 123 – (Topic 2)
Which two statements about OTV are true?(Choose two)
-
The authoritative edge device is the active forwarder for multicast and unknown unicast for all VLANs.
-
The join interface must be a Layer 2 interface.
-
no special license is required for OTV.
-
OTV requires a separate VDC if SVIs for the extended VLANs are to be configured on the same switch.
-
Only one join interface can be specified per overlay.
-
OTV runs over a distance victor routing protocol. Answer: D,E
Question No: 124 – (Topic 2)
Which Ether type is used to identify FIP?
A. 0x8914 B. 0x8906 C. 0x8915 D. 0x8905
Answer: A Explanation:
Ref:http://www.cisco.com/c/en/us/td/docs/switches/datacenter/nexus5000/sw/fcoe/513_n1_ 1/b_Cisco_n5k_fcoe_config_gd_re_513_n1_1/b_Cisco_n5k_fcoe_config_gd_re_513_n1_1
_chapter_010.html
Question No: 125 – (Topic 2)
Which option is an advantage of Cisco ACE virtual IP address tracking?
-
Troubleshooting is possible between multiple routing domains and multiple service devices.
-
Tracking is limited to a maximum of 500 tracked instances.
-
New virtual IP address implementation has multiple network touchpoints.
-
It can be used during application migration in which virtual IP addresses cannot be changed.
Answer: D Explanation:
Ref: http://www.cisco.com/c/en/us/products/collateral/application-networking-services/ace- 4710-application-control-engine/guide_c07-572616.html
Question No: 126 – (Topic 2)
In a Cisco Nexus 7000 platform configured with GLBP, which GLBP timer can be tuned to prevent unnecessary GLBP state changes during a switchover or ISSU?
-
GLBP redirect timer
-
GLBP forwarder pre-empt delay minimum timer
-
GLBP hold timer
-
GLBP pre-empt delay minimum timer
-
GLBP extended hold timer
-
GLBP nonstop forwarding timer
Answer: E
Question No: 127 – (Topic 2)
Refer to the Exhibit.
Which two statements are true? (Choose two.)
-
FC Zoning is going to be enabled automatically after the template is created.
-
With the current fabric ID configuration on the vHBA template, cannot see the new VLAN
-
All the required values have been configured in the vHBA template; after the VLAN is created, you can press OK start using the template.
-
To modify the vHBA from the service profile in the future; you first must unbind the template from the vHBA fc0 template.
-
VSAN and VLAN ID are assigned according to best practices.
Answer: B,D
Question No: 128 – (Topic 2)
When the administrator users the commit command to activate the changes to the call home configuration, it results in an error. Which is true?
-
CSF must be disabled for this to work
-
the commit call home command must be used
-
CSF must be enabled for this to work
-
The commit command is not required
Answer: C
Question No: 129 – (Topic 2)
Considering the ITIL v3 model, what are Puppet and Chef primary used for?
-
problem management
-
configuration management
-
change management
-
release management
Answer: B
Question No: 130 – (Topic 2)
What does the previously active supervisor do when quot;system switchoverquot; is issued?
-
State is transferred and then becomes ha -standby.
-
A core dump file is written, state is transferred, and the system resets.
-
State is transferred; the supervisor reloads and becomes ha -standby.
-
State is transferred; data plane operations are briefly suspended and then become has-tandby.
Answer: C
100% Ensurepass Free Download!
–500-202 PDF
100% Ensurepass Free Guaranteed!
–500-202 Dumps
EnsurePass | ExamCollection | Testking | |
---|---|---|---|
Lowest Price Guarantee | Yes | No | No |
Up-to-Dated | Yes | No | No |
Real Questions | Yes | No | No |
Explanation | Yes | No | No |
PDF VCE | Yes | No | No |
Free VCE Simulator | Yes | No | No |
Instant Download | Yes | No | No |