Introducing Cisco Data Center Networking
Question No: 131
For a router to do an IP routing process, which part of a packet must be checked before consulting the routing table?
destination IP address
source IP address
destination MAC address
source MAC address
Question No: 132
A switch is configured to be part of a VTP domain so that its VLAN database is not affected by any changes in the domain. Which mode should be configured on this switch?
Question No: 133
Which device does a network engineer use to break the network environment into smaller collision domains?
Question No: 134
What is the maximum distance that is supported by Cisco passive Twinax cables?
Question No: 135
What two address and subnet combinations are properly matched? (Choose two.)
C. 172.16.255.255/14 D. 172.25.44.96/26 E. 192.168.73.223/29
Question No: 136
Which three options represent a subnet mask that allows for 60 host addresses on a subnet? (Choose three.)
Question No: 137
What does RIPv1 send to its neighbors?
Information about changed routes
Information about new routes
The entire routing table
Information about deleted routes
Answer: C Explanation:
quot;On receiving the Routing table, the router processes each entry of the routing table as per the following rulesquot;
Question No: 138
Which process does a Cisco router perform immediately upon powering up?
booting from NVRAM
booting from ROM
Question No: 139
A router cannot forward packets to supernets. What are two causes of this problem? (Choose two.)
The router is configured with Classless IP routing.
The router is configured with Classfull IP routing.
IP Classless command is not configured on the router.
Only static routing is configured.
Variable Length Subnet Mask is not used in choosing the IP addresses.
Question No: 140
Refer to the exhibit.
An engineer has been tasked with rerouting packets flowing between the client and server via router B. The command ip route 10.10.0.0 255.255.0.0 10.1.0.1 was executed on router
B. What is the outcome of executing this command?
Packets will be rerouted using the new static route.
Packets will continue to use the path between routers A and C.
Routes from the client to the server cease routing.
Routing is now asynchronous between the client and the server.
100% Dumps4cert Free Download!
–Download Free Demo:640-911 Demo PDF
100% Dumps4cert Free Guaranteed!
–Download 2017 Dumps4cert 640-911 Full Exam PDF and VCE
|Lowest Price Guarantee||Yes||No||No|
|Free VCE Simulator||Yes||No||No|