By default, all ports on a switch are in the VLAN 1. We can verify that by typing the show vlan command from the IOS enable mode of a switch:
In the picture above, you can see that all of the 24 ports of the switch are in the same VLAN, namely VLAN 1.
Two steps are required to create a VLAN and assign a switch port to the VLAN:
- create a vlan using the vlan NUMBER global mode command
- assing a port to the VLAN by using two interface subcommands. The first command is the switchport mode access command. This command specifies that the interface is an access interface. The second command is the switchport access vlan NUMBER command. This command assigns the interface to a VLAN.
Here is an example of assigning the VLAN 2 to the interface:
The first command (vlan 2) created the VLAN 2. We’ve then entered the Fa0/1 subinterface mode and configured the interface as an access interface that belongs to VLAN 2. To verify this, we can again use the show vlan command:
Prerequisites for 200-301
200-301 is a single exam, consisting of about 120 questions. It covers a wide range of topics, such as routing and switching, security, wireless networking, and even some programming concepts. As with other Cisco certifications, you can take it at any of the Pearson VUE certification centers.
The recommended training program that can be taken at a Cisco academy is called Implementing and Administering Cisco Solutions (CCNA). The successful completion of a training course will get you a training badge.
Full Version 200-301 Dumps